STIRRED ICE BATH MODEL 813 2017-11-27T13:22:15+00:00

STIRRED ICE BATH MODEL 813

Manufacturer:

isotech

The most used temperature for calibration is 0°C.

The normal way of creating 0°C is via a mixture of ice and water in a Dewar Flask.

However, this can give errors of up to 4°C because water is densest at 4°C and so as the ice melts the temperatures at the bottom of the flask can rise to 4°C.

In the design of the ice flask offered by Isothermal Technology Ltd., these problems have been eliminated by stirring the water/ice mixture and segregating the ice from the water in the measuring zone.

This stirred ice/water bath is designed and built according to National Laboratory recommendations.

Using demineralised water, accuracies of ±0.005K are obtainable. Typically the bath will last for 4 hours before recharging with ice.

The ice is contained around and below the compartment where up to 4 probes can be placed for calibration or referencing purposes.

An option permits a water triple point cell to be maintained within the stirred ice bath.

קבצים מצורפים

Stirred Ice Bath Data Sheet

STIRRED ICE BATH MODEL 813 pdf
STIRRED ICE BATH MODEL 813
צור קשר
close slider

נשמח לעמוד לשירותכם!
מלאו פרטיכם בטופס הבא: